#Task force compressor 4 gallons manual#
#Task force compressor 4 gallons free#

This speeds up paint application and gives a smooth finish. This type sander is frequently used in automotive work but many other uses around the house, such as rust removal or paint preparation, make it a handy tool to have. The dual-action air sander should always be touching the surface when it is turned on. Larger staplers are available for attaching roofing shingles and so forth.Īir sander. Again, be sure the stapler is flat against the surface being stapled. Always be sure the gun is flat against the surface being nailed and know what is on the other side, so you won't cause damage or injury with the high pressure of the gun.Īir stapler. Never point the gun at the eyes or other parts of the body. This attachment is great for blasting away dirt, grease, and dust from hard-to-reach areas. The inflation kit attachments allow you to inflate everything from beach balls to automobile tires.īlo-gun. The quick connect couplers make it fast and simple to change tools. Perhaps two of the most obvious and useful tools are an inflation kit and quick connect couplers. They run cool, since their power source is the compressor. With few actual moving parts, maintenance is minimal. If kept properly cleaned and lubricated, air tools are virtually indestructible. Now let's talk about the available tool attachments. Leave it open until the next time the compressor is used.

After storing the hose, open the drain cock to release any accumulated moisture.

If you have a quick connect, you must either remove the hose to bleed off the air from the tank or bleed the air through the drain cocks. Then bleed the air out of the hose, remove the tool and open the regulator to bleed the air in the tank.

When finished, shut off the motor, unplug the unit, and turn off the regulator valve.

Never exceed recommended pressure for the tool or the job.

Adjust the pressure for the tool you will be using and the job you will be doing.

Turn the pressure switch on and close the tank drain valve.

Plug the unit into the correct grounded, 3-pronged outlet.

Check the oil level to make sure the compressor is properly lubricated.

There are five basic steps in the operation of an air compressor.

#Task force compressor 4 gallons free#

One other feature, most desirable to the do it yourselfer, is a toll free number to call should a question or problem arise. This does more to protect the filtering foam, inside the housing, keeping the compressor cleaner, longer.Ī belt guard is indispensable protection and the compressor should never be turned on without the guard in place.Ī hose rack is desirable for convenience and for protecting the air hose when not in use.

The best air intake filtration system will be enclosed and mounted on the side of the compressor. This protective control button must be pushed for the compressor to run once the motor has cooled down, preventing a sudden and unexpected restart. If the motor overheats, it automatically shuts off.

#Task force compressor 4 gallons manual#

When selecting and using a compressor, it is the relationship of CFM (volume of air) and PSI (force or pressure of air) that is important.Ī manual thermal overload button is important in case of overloads or if the motor overheats. Volume is measured in cubic feet per minute (CFM) or standard cubic feet per minute (SCFM). Projects and tools have both pressure and volume requirements.

PSI is the force of the pressurized air delivered to the tool. The tank maintains air at maximum pressure from 100 to 125 pounds of pressure per square inch. This valve will have a pull ring attached to it to allow you to check the valve to make certain the valve is not clogged or corroded.Īn oil level sight glass, a tank pressure gauge and, of course, a pressure regulator and gauge are important, as each tool and job has a specific pressure requirement. Other features that will be found in a quality compressor include:Īn ASME certified safety relief valve which will allow air to escape automatically if pressure in the tank should ever exceed the maximum.